Patton electronic 3040/V35 manual Contents

PATTON ELECTRONICS CO.	3040/V35	INSTALLATION AND OPERATIONS MANUAL
		139001UA
Contents
CHAPTER 1 - OPERATION
Channel Clocking		1-1
Fallback Clocking		1-1
Channel Interface		1-1
Anti-streaming		1-2
Channel Selection Modes		1-2
Channel Tail Circuits		1-3
Interface Connections		1-4
Front Panel LEDs		1-4
Channel Enable / Disable Switches		1-4
Power Supply		1-4
CHAPTER 2 - SETUP AND INSTALLATION
Power Connection		2-1
Factory Configuration Switch Settings		2-1
Disassembly		2-2
Installation		2-2
Equipment Grounding (SW15-1)		2-3
RTS To CTS Delay (SW16-1,2,3)		2-3
Anti-Streaming (SW18-1,2,3)		2-3
Receive Data Mode (SW18-7)		2-3
Control Turn-Off Delay in “DATA” Switching Mode (SW15-3,4)		....................................................... 2-4
Switch on Data / Control (SW17-5,6,7,8)		2-4
Internal Baud Rates (SW15-5,6,7,8)		2-4
Fallback Clock Enable (SW16-7)		2-5
Fallback Clocking From Sub-Channel 4 (SW16-8)		2-5
Fallback Mode Selection (SW16-6)		2-5
TX Clock Source Selection (SW17-1,2,3)		2-6
TX Clock Pin Selection (SW17-4)		2-6
RX Clock Source Selection (SW18-4,5,6)		2-6
Tail Circuit Buffers (SW16-4)		2-7
Port DCE/DTE Selection (SW5 thru SW14)		2-7
DTR / DSR Forced Active (JP8 thru JP12)		2-8
FACTORY Test Jumpers (JP1, JP2 and JP3)		2-8
APPENDIX
Typical Application		A-1
Typical Tail Circuit Configuration		A-1
Interface Pins Supported		A-2
Master DTE / Sub-Channel DTE Interface Flow Diagram		A-3
Master DTE / Sub-Channel DCE Interface Flow Diagram		A-3
Master DCE / Sub-Channel DCE Interface Flow Diagram		A-4
Master DCE / Sub-Channel DTE Interface Flow Diagram		A-4
TECHNICAL SPECIFICATIONS		A-5
Strapping Guide		A-6

iii