Patton electronic 4940 manual Additional information

SmartNode 4940 Getting Started Guide 4 • Initial configuration

Load a new application image (SmartWare) via the serial link

The Bootloader supports the ‘X-Modem’ and ‘Y-Modem’ protocols to download application images via the serial link of the console. Do the following to initiate the download:

Step	Command	Purpose
1	RedBoot> load -r -v -m {	Downloads an application image into the volatile memory
	xmodem ymodem } -b	(RAM) from where the SmartNode could directly execute it.
	base_address	‘xmodem’ or ‘ymodem’: Specify the protocol to be used, X-
		Modem or Y-Modem
		base_address: memory location where to store the application
		image. Use the default address 0x1800100
		Execute the above RedBoot command first, then start the trans-
		fer from the terminal program with the command ‘Send file via
		X-Modem’ (or similar).
5	RedBoot> fis delete -n 1	Deletes the first application image.
		Reply with ‘y’ to the confirmation request.
6	RedBoot> fis create	Stores the downloaded application image to the permanent
		memory (flash:).
		Reply with ‘y’ to the confirmation request.
7	RedBoot> fis list -l	Checks whether the image has been successfully stored,
		whether it is the desired Release and Build, and whether it is
		valid.
8	RedBoot> go	Starts the application image that was downloaded to the vola-
		tile memory (RAM).

Note This type of download takes about 25 minutes since it uses a serial link at only 9600 bps.

Additional information

For detailed information about configuring and operating guidance, set up procedures, and troubleshooting, refer to the SmartNode Series SmartWare Software Configuration Guide on the CD-ROM.

Additional information 33