Patton electronic 4940

Appendix D Port pin-outs

Chapter contents

Introduction..........................................................................................................................................................53

Console port..........................................................................................................................................................53

Ethernet................................................................................................................................................................53

PRI port................................................................................................................................................................54

Contents

Main SmartNode 4940 Series Page Summary Table of Contents Table of Contents Page Page List of Figures List of Tables About this guide Audience Structure Precautions Page Typographical conventions used in this document Page SmartNode 4940 overview Page SmartNode 4940 rear panel The SmartNode 4940 rear panel ports are described in table3. Figure 2. SN4940 rear panel figure 2 figure2 figure 3 figure2 figure 2 SmartNode 4940 front panel Figure 3 shows SmartNode 4940 front panel LEDs, the LED definitions are listed in table4. Figure 3. SmartNode 4940 front panel Page Page ApplicationConvert Legacy PBX to VoIP Chapter 3 SmartNode installation Planning the installation Installing the gateway Page Page Chapter 4 Initial configuration Configuring the desired IP address Connecting the SmartNode to the network Loading the configuration (optional) Bootloader Start-up with factory configuration Page Additional information Chapter 5 Contacting Patton for assistance Contact information Warranty Service and Returned Merchandise Authorizations (RMAs) Page Appendix A Compliance information Compliance Radio and TV Interference FCC Part 68 (ACTA) Statement Industry Canada Notice CE Declaration of Conformity Authorized European Representative Appendix B Specifications Voice connectivity Data connectivity Voice processing (signalling dependent) Fax and modem support Voice signalling Voice routingsession router IP services Management System Physical Identification of the SmartNode devices via SNMP Page Page Console See section Console port on page 53 for console port pin-outs. Ethernet Figure 9. Typical Ethernet straight-through cable diagram for 1000Base-T Figure 8. Typical Ethernet straight-through cable diagram for 10/100Base-T E1 PRI Figure 11. E1 PRI port crossover cable Figure 10. Connecting an E1 PRI port to an NT1 T1 PRI Cross-over cable Figure 13. T1 PRI crossover cable Figure 12. Connecting a T1 PRI port to an NT device NT Page This section provides pin-out information for the ports of the SmartNode. Console port Pins not listed are not used. Configuration settings: 9600 bps, 8 bits, no parity, 1 stop bit, no flow control N/C means no internal electrical connection. Ethernet PRI port Pins not listed are not used. Page The factory configuration settings for SmartNode 4940 are as follows: Appendix F End user license agreement End User License Agreement