Introduction | Patton electronic 5400 specs

SmartNode 5400 Getting Started GuideE • SmartNode 5400 factory configuration

Introduction

The factory configuration settings for SmartNode 5400 are as follows:

#----------------------------------------------------------------	#
#	#
# 5400 Series	#
# Factory configuration file	#
#	#
#----------------------------------------------------------------	#
dns-relay
sntp-client
sntp-client server primary 129.132.2.21 port 123 version 4
system
ic voice 0
low-bitrate-codec g729
profile napt NAPT_WAN
profile dhcp-server DHCPS_LAN
network 192.168.1.0 255.255.255.0
include 1 192.168.1.10 192.168.1.99
lease 2 hours
default-router 1.192.168.1.1
domain-name-server 1.192.168.1.1
context ip router
interface WAN
ipadress dhcp
use profile napt NAPT_WAN
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
interface LAN
ipadress 192.168.1.1 255.255.255.0
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
context ip router
dhcp-server use DHCPS_LAN
port ethernet 0 0
medium auto
encapsulation ip
bimd interface WAN router
no shutdown
port ethernet 0 1
medium auto
encapsulation ip
bind interface LAN router
no shutdown

Introduction

58

Image 58

Patton electronic 5400 manual Introduction

Contents

SmartNode 5400 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Shdsl Basic Configuration Cabling List of Figures List of Tables Audience About this guideStructure Precautions Impaired functioning Safety when working with electricity General observations General conventions Typographical conventions used in this documentConvention Meaning Chapter contents General information SmartNode 5400 overview SN5400 model codes SmartNode 5400 rear panel SmartNode 5400 rear panel ports are described in table WAN ETH 0/0 SmartNode 5400 front panel SN5400 LED Description Applications overview Introduction Typical application SmartNode installation Site log Planning the installationNetwork Diagram Network information Installing the gateway router Connecting the 10/100/1000Base-T Ethernet LAN and WAN cables Internal AC Power Supply Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PC Login Configuring the desired IP addressFactory-default IP settings Changing the WAN IP address Connecting the SmartNode to the network LAN Loading the configuration optional Start-up with factory configuration BootloaderStart Bootloader Step Command Purpose Step Command Purpose Load a new application image SmartWare via the serial link Xmodem ymodem -b Additional information Shdsl Basic Configuration Line Setup Configuring PPPoE Configuration Summary Using PVC channels with PPPoE Setting up permanent virtual circuits PVCUsing PVC channels in bridged Ethernet mode Command Purpose Troubleshooting DSL Connections Diagnostics Contacting Patton for assistance Contact information Warranty coveragePatton support headquarters in the USA Out-of-warranty service RMA numbers Appendix a Compliance information CE Declaration of Conformity Low-Voltage Directive SafetyCompliance Authorized European Representative Appendix B Specifications Data connectivity Voice processing signalling dependentVoice signalling Fax and modem support System IP servicesManagement Physical Shdsl Daughter Card if applicable Factor Specs Identification of the SmartNode devices via Snmp SmartNode Model SysObjectID Appendix C Cabling Connecting a serial terminal Console Ethernet Appendix D Port pin-outs Pin Signal Console port Shdsl port Appendix E SmartNode 5400 factory configuration Introduction Appendix F End user license agreement End User License Agreement Termination Other licenses