BACK PANEL FEATURES
10 | 11 | 9 | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
12 | 13 | 8 |
8.INPUT SECTION
The ICA™ Series comes standard with plugable input connectors and individual channel rotary attenuators. Connections at the input connector permit the audio signal ground to be connected or lifted from the chassis ground.
9.OUTPUT BARRIER STRIP
A barrier strip is provided for connection of loudspeakers with bare wire or spade lug connectors. This barrier strip can accommodate up to two
10.IEC POWER CONNECTOR
A standard IEC power connector is located at the upper left corner of the amplifier rear panel.
An AC mains cord having an appropriate AC plug for the intended operating voltage is included.
NOTE: FOR UK ONLY
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green, or colored green and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. (3). The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red.
11.CIRCUIT BREAKER
A resettable, protective AC circuit breaker is located at the upper left of the amplifier back
panel. If the breaker has tripped, push it back in to return the amplifier to operating condition. If the breaker continues to trip, the amplifier needs servicing. Do not continue to reset the breaker because severe internal damage and safety hazards could occur!
12.SEQUENTIAL TURN-ON CONNECTOR
The ICA™ Series comes standard with
6
