(2)Insert two 1.5 Volt (AA) batteries into the battery compartment, being careful of the proper polarity as illustrated in Fig.4
NOTE: When transmitter is not in use, make sure it is switched off.
If the transmitter will not be used for some time, please remove
the batteries from the battery compartment to avoid battery leakage which could result in damage to the microphone. If rechargeable batteries are used, remove and recharge when necessary.
3. OPERATING INSTRUCTIONS
(1)Select GT/MT Switch (9) position: Determine the use of the Belt Pack Transmitter. If a lavalier or headset microphone will be used, the switch should be set in the MT position. If using a guitar/bass or with a
(2)Power On: When powering up the transmitter, switch the power switch (2) to the ON position. The Battery Status indicator will flash briefly, indicating normal operational status. (b) When the indicator remains illuminated or does not illuminate at all, the battery level is low or exhausted and must be replaced for continued operation.
(3)Determine Channel/Group: After you power up the transmitter, check to see that it is assigned to the same channel/group as the receiver. If you find they do not match then follow the G/CH setup procedures (pages 8 – 9).
32
