p. 43
master modules—M1, M2
intercom interconnect features
The console is designed to interconnect with a ClearCom compatible
intercom system. Three-pin male and female XLR’s are located on the
console rear-panel for intercom hookup and loop-thru.A separate four pin
XLR connector is located under the arm rest for connection to a standard
intercom headset.

console-to-intercom level and switch

Controls the amount of console signal fed to the intercom system as
selected by the source selection switches located within the headphone
system.

link headphone/intercom switch

Allows both intercom and console signals to be monitored on the high
quality system headphones AND the intercom headset.

comms level

This control determines the level of the intercom signal in the COMMS
headset or,if the link phones switch is depressed, the amount of intercom
signal mixed into the console headphones.

call button

Sends an intercom call command when pressed,and will also illuminate to
indicate a call signal is being received.The operator also has the option,by
way of the COMMS FLASHswitch, of having the console Little-Lites flash
upon receiving a call signal. Additionally,hi-intensity blue LEDs in the meter
bridge will flash when a call signal is received.Their brightness is controlled
by the COMMS CALL LED switch in the upper section of the module.