Pelco C1487M-D operation manual Park Time Minutes, Pattern Length

NOTE: Preset 1 must be programmed for the dome to park.

CAUTION: If the length is changed, all patterns that

were stored are erased.

PARK TIME MINUTES

This feature causes the dome to park at preset 1 after a programmed number of minutes of control inactivity. The time can be set from 1 minute to 720 minutes (12 hours), or it can be set to zero, which disables this feature.

To change the park time:

1.Program preset 95 (28 if in 32-preset mode; refer to the Preset Functions section) to access the main menu (refer to the Main Menu Access section). The main menu will appear.

2.If the cursor (>) is not beside Other, move the joystick up or down to position the cursor beside Other.

3.Press the Iris Open button to enter the Other submenu.

4.Move the joystick up or down to position the cursor beside Park Time Minutes.

5.Press the Iris Open button. A star will appear beside Park Time Minutes and the cursor will move to the right beside the current park time.

6.Move the joystick up or down to change the park time.

7.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.

SCAN SPEED

The scan speed is adjustable from 1-40 degrees per second. This occurs in three scan modes: auto, random, and frame scan.

To change the scan speed:

1.Program preset 95 (28 if in 32-preset mode; refer to the Preset Functions section) to access the main menu (refer to the Main Menu Access section). The main menu will appear.

2.If the cursor (>) is not beside Other, move the joystick up or down to position the cursor beside Other.

3.Press the Iris Open button to enter the submenu entitled Other.

4.Move the joystick up or down to position the cursor beside Scan Speed deg/s.

5.Press the Iris Open button. The cursor will move to the right beside the number of degrees.

6.Move the joystick up or down to toggle through the number of degrees (1-40) until you reach the number you want. (If set on a low number, the scan will appear to barely move but is still functioning.)

7.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.

PATTERN LENGTH

(This section applies to Spectra II™ only.)

You can set the pattern length to 1.5, 3, or 6 minutes or have two half-patterns of .75, 1.5, or 3 minutes long.

To set the pattern length:

1.Program preset 95 (28 if in 32-preset mode; refer to the Preset Functions section) to access the main menu (refer to the Main Menu Access section). The main menu will appear.

2.If the cursor (>) is not beside Other, move the joystick up or down to position the cursor beside Other.

42 Pelco Manual C1487M-D (7/99)