NOTE: Pattern length is set on the secondary menu en- titled Other.
NOTE: To make the pattern run to its end when an alarm activates it, make alarm dwell time longer than pat- tern length. Therefore, if the alarm goes away before the end of the pattern, the pat- tern will continue until the dwell times out.
ALARM PATTERN
(This section applies to Spectra II™ only.)
In response to an alarm, the Spectra II™ dome can do either one full pattern (1.5, 3, or 6 minutes long) or two half patterns (.75, 1.5, or 3 minutes long). You can choose one of the following for each of the seven alarm inputs:
•Full Pat (run full pattern)
•Half Pat 1 (run half pattern 1)
•Half Pat 2 (run half pattern 2)
•No Pattern
To change the alarm pattern:
1.Program preset 95 (28 if in
2.If the cursor (>) is not beside Alarms, Zone Blank, move the joystick up or down to position the cursor beside Alarms, Zone Blank.
3.Press the Iris Open button to enter the Alarms, Zone Blank submenu.
4.Move the joystick up or down to position the cursor beside Alarm Pattern.
5.Press the Iris Open button to enter the Alarm Pattern submenu.
6.Move the joystick up or down to position the cursor beside the number of the alarm input for which you want to set the pattern.
7.Press the Iris Open button. The cursor will move to the right beside the words Full Pat, Half Pat 1, Half Pat 2, or No Pattern.
8.Move the joystick up or down to toggle between the choices.
9.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.
ZONE BLANK
(This section applies to Spectra II™ only.)
This feature lets you define any of eight zones as blanked for video when the camera pans into the zone area. The choices are On and Off. On means video blanking is in effect. The default is Off.
To change the blank zone setting:
1.Program preset 95 (28 if in
2.If the cursor (>) is not beside Alarms, Zone Blank, move the joystick up or down to position the cursor beside Alarms, Zone Blank.
3.Press the Iris Open button to enter the Alarms, Zone Blank submenu.
4.Move the joystick up or down to position the cursor beside Zone Blank.
5.Press the Iris Open button to enter the Zone Blank submenu.
6.Move the joystick up or down to position the cursor beside the number of the zone for which you want to set the blank option.
7.Press the Iris Open button. The cursor will move to the right beside the word On or Off.
8.Move the joystick up or down to toggle between the words On and Off.
9.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.
Pelco Manual | 39 |
