10.If you are installing an outdoor model, plug the
11.Remove the two screws and the tube of Loctite® from the parts bag. Apply a drop of Loctite® to each screw.
12.Push the lower dome inside the back box, line up the screw holes, and install the two screws.
SURFACE-MOUNT INSTALLATION
NOTE: For hard ceilings, such as concrete, where the wiring must be installed in
1.Use a hole saw to drill a hole in the ceiling where you want to hang the pendant dome.
2.Bring the wiring for the dome to the opening. Refer to the Wiring section.
3.Refer to Figure 10. Loosen the thumbscrew inside the back box and open the hinged door.
4.Remove the gasket and the top mount from the back box by taking out the three screws and lock washers.
5.Attach the back box to the ceiling using #8 hardware (not supplied).
6.Attach the wiring to the back box. Refer to the Back Box Connections section.
7.Install the dome drive. Refer to the Dome Drive section.
8.Remove the
9.Refer to Figure 16. Hanging down from the back box is a short cable (the trim ring leash). Hold up the lower dome near the back box so that the trim ring leash touches the lower dome. Line up the two screw holes in the trim ring of the lower dome with the two screw holes in the back box. Place a finger on the edge of the trim ring where the leash touches the lower dome.
10.Look inside the lower dome and note which of the six retainer screws is closest to your finger. Remove this screw and attach the trim ring leash to the screw. Reinstall the screw securely and make sure the leash will hold the lower dome.
11.If you are installing an outdoor model, plug the
12.Remove the two screws and the tube of Loctite® from the parts bag. Apply a drop of Loctite® to each screw.
13.Push the lower dome inside the back box, line up the screw holes, and install the two screws.
OPERATION
The red LED in the interconnect door in the back box lights when power is turned on, and the fan operates to exhaust heat from inside the back box when a dome drive is installed.
If you have an outdoor pendant model with a heater, the heater elements in the back box turn on at 70°F (21°C) and turn off at 85°F (29°C). The heater element in the lower dome turns on at 40°F (4°C) and turns off at 60°F (16°C). The fans in the back box operate continuously when a dome drive is installed.
Pelco Manual | 23 |
