Pelco C544M, C1501M, C1503M, C549M-A manual Link Cameras File, 2-20 C1510M-A2/03, Section, Figure

3.2 CAMERAS FILE

Close the Comms tab and open the Cameras file by clicking on its tab. Identify the ports on the MXB to which monitor-outs from the SAT are at- tached. Configure the Cameras file accordingly.

Figure 2-7

Programming the Cameras File

3.3 LINK CAMERAS FILE

Open up the Link Cameras tab next. In the Link Cameras file, assign unique logical numbers for the cameras to dis- tinguish them from non-SAT types. Ac- cess to link cameras from CM9760- KBDs attached to the system node use the logical numbers just referred to, to call the satellite camera desired. For each line entry that that defines a link camera, enter the PTZ port number to which the SAT for that camera is at- tached and also enter the port address (1-16, on the SAT), to which the Link Camera is attached. An example Link Camera file is shown to the right.

Figure 2-8

Programming the Link Cameras File

2-20C1510M-A (2/03) SECTION 2