Pelco C578M, C538M Operating Sequences, Operation, CM9760-SAT, Run a Sequence Forward or Backward

1.4 OPERATING SEQUENCES

Each monitor (video output) has one 16-step sequence that can be run forward or backward, stopped (by placing the sequence on hold), or stepped through by pressing either PREV or NEXT while the sequence is on hold. The sequence status indicator (see Figure 3-9) displays the current state of a monitor sequence.

1.4.1 Run a Sequence Forward or Backward

Hold down either the NEXT (forward) or the PREV (backward) key for two seconds to begin running a sequence. The sequence status indicator under the camera number displays an F (for forward) or B (for backward) when the sequence begins.

Figure 3-9

Sequence Status and Sequence Display Characteristics

Figure 3-10

Forward and Backward Sequence Operation

1.4.2 Change the Direction of a Sequence

The direction of any currently operating sequence can be reversed. If, in the examples of Figure 3-10, you press the PREV button while the sequence is running forward, the sequence will run backward. The sequence status indicator will reflect this change by changing from F to B. Similarly, pressing the NEXT button while the sequence is running backward starts it running forward.

1.4.3 Step Through a Sequence

You can step through a camera sequence in the order the sequence is running (forward or backward) or when a sequence is on hold.

•When the Sequence Status Indicator displays B (sequence is running backward), press the PREV key to step through the sequence.

•When the Sequence Status Indicator displays F (sequence is running forward), press the NEXT key to step through the sequence.

•When the Sequence Status Indicator displays H (sequence is on hold), press the PREV button to step backward through the sequence or the NEXT button to step forward through the sequence.

Figure 3-11

Sequence Hold

1.4.4 Stop a Sequence

The two ways to stop a sequence are as follows:

•Press the HOLD button. The indicator under the camera

number displays an H (for hold).

• Select a camera.

1.4.5 Turn OFF a Sequence

Manually select a camera or press the CAM button.

NOTE: Whether or not a camera is available at your monitor viewing location is determined in the access menu (see Section 2, Access Programming Menu). Of those available, which CAM is used and the order of its appearance is determined by the monitor CAMERA SE- QUENCE sub-menu (see Section 2, Monitor Programming Menu-Page 2 of 3).

OPERATION CM9760-SAT 3-3