Pelco C3432M-F manual Side Conduit Installation

SIDE CONDUIT INSTALLATION

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from the back box.

2.Remove the conduit plug from the cover. Install a 0.75-inch (1.91 cm) threaded conduit connector (not supplied) into the conduit hole in the cover.

3.Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware when installing the system outdoors.

4.Install the camera module into the back box before installing the back box into the cover. Rotate the camera module to access the mounting holes inside the back box. Refer to Camera Module on page 19 for more information.

5.Connect the cable/wires (refer to Wiring Tables on page 14 for information).

6.Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

0.75-INCH CONDUIT

CONNECTOR

REMOVE

CONDUIT PLUG

COVER

BACK BOX

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 8. Side Conduit Installation

C3432M-F (6/08) 13