Pelco C3432M-F manual Plaster Ring Installation

404 PLASTER RING INSTALLATION

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from the back box.

2.Pull cable/wires into the cover. Use three supplied 6-32 x 0.75-inch Phillips pan head screws or two supplied 8-32 x 0.75-inch Phillips pan head screws to attach the cover to an installed 404 plaster ring. Use stainless steel hardware when installing the system outdoors.

3.Install the camera module into the back box before installing the back box into the cover. Rotate the camera module to access the mounting holes inside the back box. Refer to Camera Module on page 19 for more information.

4.Connect the cable/wires (refer to Wiring Tables on page 14 for information).

5.Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

CEILING/

WALL

404 PLASTER RING (NOT SUPPLIED)

COVER

6-32 X 0.75-INCH OR 8-32 X 0.75-INCH

PHILLIPS PAN

HEAD SCREWS (SUPPLIED)

BACK BOX

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 7. 404 Plaster Ring Installation

12 C3432M-F (6/08)