Pelco C3432M-F manual Cover and Back Box Installation, Basic Surface Installation

Cover and Back Box Installation

The IP110 Series Camclosure integrated camera system mounts only to a surface. It can be wired through the cover into a surface, electrical box, plaster ring, or through a side conduit opening.

BASIC SURFACE INSTALLATION

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from the back box.

2.Cut out the hole for the cable/wiring. Pull the cable/wires through the mounting surface and then through the hole of the cover.

3.Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware when installing the system outdoors.

4.Install the camera module into the back box before installing the back box into the cover. Rotate the camera module to access the mounting holes inside the back box. Refer to Camera Module on page 19 for more information.

5.Connect the cable/wires (refer to Wiring Tables on page 14 for information).

6.Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

COVER

MOUNTING SCREWS (NOT SUPPLIED)

8-32 X 0.375-INCH	BACK BOX
PHILLIPS PAN HEAD
SCREWS WITH WASHERS
(SUPPLIED)

Figure 5. Basic Surface Installation

10 C3432M-F (6/08)