Reset Button
Use the reset button located on the board inside the back box to access the following modes:
Mode | Function | Unit Status Indicator Light |
|
|
|
Configuration | Starts reset LED | Flashes green. |
| selection sequence. |
|
|
|
|
Reboot | Restarts the unit. | Flashes green and red simultaneously, when entering |
|
| this mode. The LED then flashes green when mode is |
|
| selected and during the reboot. |
|
|
|
Reset | Resets unit to factory | Flashes red when entering this mode. Flashes red when |
| default settings and | mode is selected, and then flashes green when camera |
| then restarts unit. | restarts. Camera is offline during reset mode. |
|
|
|
Cancel | Cancels any | No light. |
| configuration or reset |
|
| action. |
|
|
|
|
To access one of these modes:
1.Press and hold the reset button. The unit starts cycling through the modes; hold the button for four seconds to access (cycle through) each mode. The unit status indicator flashes the color for the current mode (refer to the table above).
2.When the color of the desired mode appears, release the button.
NOTES:
•If there is no configuration activity for 15 minutes, the camera will automatically exit the reset mode.
•The LED is not lit during normal operation.
RESET
BUTTON
RED / GREEN LEDS
Figure 27. Location of Reset Button and LEDs
33 |