Pelco C3432M-F manual 4S ELECTRICAL BOX INSTALLATION

4S ELECTRICAL BOX INSTALLATION

1.Attach an ICS110-AP adapter plate (not supplied) to a 4S electrical box. Use two 8-32 x 0.75-inch Phillips flat head screws (supplied with both the IP110 and the adapter plate).

2.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from the back box.

3.Pull the cable/wires into the cover.

4.Attach the cover to the adapter plate with four 8-32 x 0.375-inch Phillips pan head screws (supplied with the adapter plate). Use stainless steel hardware when installing the system outdoors.

5.Install the camera module into the back box before installing the back box into the cover. Rotate the camera module to access the mounting holes inside the back box. Refer to Camera Module on page 19 for more information.

6.Connect the cable/wires (refer to Wiring Tables on page 14 for information).

7.Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

4S STANDARD ELECTRICAL BOX

CEILING/

WALL

8-32 X 0.75-INCH	ADAPTER PLATE
PHILLIPS FLAT
HEAD SCREWS	(ICS110-AP)
(SUPPLIED)

COVER

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS (SUPPLIED WITH ICS110-AP)

BACK BOX

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 6. 4S Electrical Box Installation

C3432M-F (6/08) 11