Recommended Tools and Supplies
You need the following tools and supplies to install the system in a
•
•
•
•
A #2 Phillips screwdriver
A
An installation template, helpful in slide assembly placement and alignment
Masking tape or a
Installing the Rack Kit
NOTES: If you purchased a Dell rack along with your PowerApp system, the slide assemblies may be preinstalled in the rack.
For instructions on installing the PowerApp system itself, see “Installing the System in the Rack” found later in this guide.
To install the slide assemblies in the rack, perform the following steps:
1.Remove the rack’s front and back doors.
2.Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
Removing the Doors From the 42-U Rack
CAUTION: To prevent personal injury due to the size and weight of the doors, never attempt to remove the doors by yourself.
CAUTION: Store the two doors where they will not injure someone if the doors accidently fall over.
1.Open the latch on the front door (see Figure 10).
Slide the button cover up as far as it will go, press the push button, rotate the handle clockwise until the latch releases, and then pull the door open.
support.dell.com | Dell PowerApp 100 Appliances Rack Installation Guide | 13 |
