Pelco dx8100 manual Setting Up Audio Output

SETTING UP AUDIO OUTPUT

The DX8100 delivers a line-level monaural signal through a standard 0.125-inch phone jack on the rear panel of the DVR. It is recommended that the audio output of the DX8100 be connected to an amplifier in order to boost the output signal to a level that is sufficient to drive a speaker. Figure 94 illustrates an example of an audio output configuration.

Some speaker systems integrate both amplifiers and speakers in a single unit. Such a system can be connected directly to the audio output of the DX8100 without the need for external amplification.

To setup the audio output:

1.Connect the audio output of the DX8100 to an audio amplifier.

Use an audio cable with a 0.125-inch miniature male phone plug on one end to connect to the audio output of the DX8100. Ensure that the opposite end of the cable has the appropriate connectors for connection to your amplifier.

2.Connect the audio amplifier to a speaker.

IN1

IN2

IN3

IN4

IN5

IN6

IN7

IN8

IN9

IN10

IN11

IN12

IN13

IN14

IN15

IN16

OUT1

OUT2

OUT3

OUT4

OUT5

OUT6

OUT7

OUT8

OUT9

OUT10

OUT11

OUT12

OUT13

OUT14

OUT15

OUT16

ALARM INPUTS

RELAY OUTPUTS

1

2 2 4

5 6

7

8 GND

1

2

2 4

5 6

7 8

GND

9

10 11 12

13 14

15

16

9

10

11 12

13 14

15 16

SPEAKER

AUDIO AMPLIFIER

MINI MALE PHONE PLUG

Figure 93. Audio Output Configuration Example

70 C2629M-A (6/07)