CONFIGURING DX8100 ATM/POS COMMUNICATION OPTIONS
Once you have installed the ATM/POS device(s), you must configure the DX8100 to communicate with the ATM/POS device(s). This section describes how to set up DX8100 ATM/POS options. For more information about configuring DX8100 ATM/POS options, refer to the DX8100 Operations and Programming Manual or the DX8100 server online Help.
To configure the DX8100 to communicate with the ATM/POS device(s):
1.On the DX8100 toolbar, click . The Setup dialog opens to the Camera page.
2.In the Setup dialog box, click . The Network page is displayed.
3.In the Network page, click the Port/Device tab. The Port/Device page is displayed.
4.Do the following:
a.In the Communication Port
b.In the device
c.Configure the following port settings using the
•Interface mode
•Baud rate
•Parity
•Data bits
•Stop bits
Figure 108. Port/Device Page
84 |