Pelco FR85011A manual Mounting the Transmitter/Receiver Using the Wall Clip

Mounting the Transmitter/Receiver Using the Wall Clip

NOTE: Before mounting the FT85011A transmitter/FR85011A receiver to a wall, ensure that there is adequate space at both ends for viewing the front-panel LEDs and for making the various rear-panel cable connections.

To attach the FT85011A transmitter/FR85011A receiver to a wall using the supplied wall clip, refer to Figure 5 and do the following:

1.Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall using two screws (not provided).

2.Slide the module into the clip until the two holes on the bottom of the module align with the two holes on the lower flange of the clip.

3.Attach the module to the clip using the two Phillips pan head screws provided for the clip.

UPPER

FLANGE

VERTICAL

MOUNTING HOLE (2)

HORIZONTAL

TRANSMITTER/MOUNTING HOLE (2) RECEIVER

LOWER

SCREW, PHILLIPS WALL CLIPFLANGE

PAN HEAD WITH

LOCK WASHER (2)

Figure 5. Mounting the FT85011A Transmitter/FR85011A Receiver Using the Wall Clip

C2604M (7/06) 15