Command Line Interface 97
Line Commands
Set Vmodem
Description Configures the vmodem settings for the serial line.
User Level Admin
Syntax
Options failure-string
success-string
host
port
style
suppress
Show Interface
Description Shows the network interface information.
User Level Admin
Syntax
Show Telnet-Client
Description Shows the telnet client settings for a line.
User Level Admin
Syntax
Show UDP
Description Shows the UDP settings for the line.
User Level Admin
Syntax
<end_ip_address>
The last host IP address in the range of IP addresses (for IPV4, not required for IPV6)
that the Device Server will listen for messages from and/or send messages to.
set vmodem line [failure-string <string>]
[success-string <string>] [host <config_host>]
[port <TCP_port>|0] [style numeric|verbose] [suppress on|off]
String that is sent to the serial device when a connection fails. If no string is entered,
then the string NO CARRIER will be sent.
String that is sent to the serial device when a connection succeeds. If no string is
entered, then the string CONNECT will be sent with the connecting speed, for example
CONNECT 9600.
The target host name.
The port number the target host is listening on for messages.
One of the following:
zVerbose—Return codes (strings) are sent to the connected device.
zNumeric—The following characters can be sent to the connected device:
1 Successfully Connected
2 Failed to Connect
4 Error
If set to No, connection success/failure indication strings are sent to the connected
device, otherwise these indications are suppressed.
show interface [brief|ethernet]
show telnet-client
show udp