Command Line Interface 89
User Commands
Set User Session
Description Configures a user’s session settings. See Set User Session on page 82 for the options
descriptions.
User Level Admin
Syntax
Show Default User
Description Shows the Default User’s settings.
User Level Admin
Syntax
Show User
Description Shows user configuration settings.
User Level Admin
Syntax
Options <configured_user>
Show the settings for the specified user.
.
Show the settings for the current user.
sess-timer
The amount of time, in seconds, that the session timer will run. Use this timer to
forcibly close a user’s session (connection). When the session timer expires, the Device
Server will end the connection. The default value is 0 (zero), meaning that the session
timer will not expire (the session is open permanently, or until the user logs out). The
maximum value is 4294967 seconds. The User Session Timer will override the Line
Session Timer, with the exception of reverse Telnet sessions.
port
When the User Service is Telne t, this is the target port number. The default value will
change based on the type of Service selected; the most common known port numbers
are used as the default values.
set user .|<username> session 1|2|3|4|* [auto on|off]
[type off|telnet]
set user .|<username> session 1|2|3|4|* telnet-options
[host <config_host>] [port <TCP_port>]
[termtype <terminal_name>] [line-mode on|off]
[map-cr-crlf on|off] [local-echo on|off]
[echo <00-7f>] [eof <00-7f>] [erase <00-7f>] [intr <00-7f>]
[quit <00-7f>]
show default user
show user <configured_user>|.