Heat & Glo LifeStyle 6000 GDVFL, 6000 XLS manual Step Before Lighting Fireplace After Installation

31

Step 11

Before Lighting

the Fireplace

Step 12

Lighting the

Fireplace

After the

Installation

Before lighting the fireplace, be sure to do the following:

Review safety warnings and cautions

•Read the Safety and Warning Information section at the beginning of this Installers Guide.

Double-check for gas leaks

•Before lighting the fireplace, double-check the unit for possible gas leaks.

Double-check vent terminations and front grilles for obstructions.

•Before lighting the fireplace, double-check the unit for possible obstructions that could be blocking the vent terminations or the front grilles.

Double-check for faulty components

•Any component that is found to be faulty MUST BE replaced with an approved component. Tampering with the fireplace components is DANGEROUS and voids all warranties.

A small amount of air will be in the gas supply lines. When first lighting the fireplace, it will take a few minutes for the lines to purge themselves of this air. Once the purging is complete, the fireplace will light and will operate normally.

Subsequent lightings of the fireplace will not require this purging of air from the gas supply lines, unless the gas valve has been turned to the OFF position, in which case the air would have to be purged.

You’ve reviewed all safety warnings, you’ve checked the fireplace for gas leaks, you know the vent system is unobstructed, and you’ve checked for faulty components. Now you’re ready to light the fireplace.

WARNING

PLEASE REFER TO THE USER’S MANUALFOR ALL CAUTIONS, SAFETY, AND WARNINGINFORMATION PERTAINING TO THE LIGHTINGAND OPERATION OF THE FIREPLACE.

LEAVE THIS INSTALLATION MANUAL WITH THE APPLIANCE FOR FUTURE REFERENCE.