Diagram of the6000 Series | Heat & Glo LifeStyle 6000 GDVFL instruction

3

When planning a fireplace installation, it’s necessary to determine:

•Where the unit is to be installed.

•The vent system configuration to be used.

•Gas supply piping.

•Electrical wiring.

•Framing and finishing details.

•Whether optional accessories—devices such as a fan, wall switch, or remote control—are desired.

If the fireplace is to be installed on carpeting or tile, or on any combustible material other than wood flooring, the fireplace should be installed on a metal or wood panel that extends the full width and depth of the fireplace.

Figure 1. Diagram of the6000 Series

Image 6

Heat & Glo LifeStyle 6000 GDVFL, 6000 XLS manual Diagram of the6000 Series

Contents

Heat-N-Glo Fireplace Safety and Warning Information Table of Contents Replacement Parts Approvals and Codes Installation CodesHigh Altitude Installations Codes Getting Started Diagram of the6000 Series Locating Installing the FireplaceStep Fireplace Step Framing Fireplace Model Models26-1/4 Step Installing Vent System Vent System Approvals DV-90D Corner Installation Venting with One 90 Elbow Venting with Two 90 Elbows Venting with three 90 elbows Installing Vent Components Attach the First Vent Component to the Starting Collars Adding Venting Components Install Support Brackets Continue Adding Vent Components Installing Support Brackets 4. Install Firestops 12 Hole and Vent Pipe 11 Hole and New Framing Members Vent Termination Attic Firestop Round and Trapezoid Termination Caps If Exterior Walls are Finished with Major U.S. Building Codes Minimum Height from Roof to Lowest Discharge Opening Standing Pilot Ignition System Step Positioning Leveling, Securing FireplaceStep Gas Control Systems Direct Spark Ignition DSI System Step Gas Supply Line Mm hook-up at the unit Step Gas Pressure Requirements Pressure Natural Gas Propane Optional Accessories Step Wiring FireplaceFor Standing Pilot Ignition Wiring Remote Wall Switch For Direct Spark Ignition DSI Wiring Fan Wiring Diagram Direct Spark Ignition DSI Wiring Diagram Step Finishing Step Installing Trim Logs, Ember Material Installing the TrimHearth Extensions Positioning the Logs Save the log instructions with this manualPlacing the Ember Material Glass Assembly Double-check for faulty components Step Before Lighting Fireplace After InstallationReview safety warnings and cautions Double-check for gas leaks Fireplace Maintenance Maintaining and Servicing Your Fireplace Burner Flame Patterns Replacement Parts Accessories Standing Pilot Only DSI Ignition Only Both Standing Pilot and DSI Ignition 20 X6000XLS 20 X Models Mesh