IOLAN Device Server User’s Guide, Version 1.0 115
Utilities Appendix B
B
Introduction
This chapter provides information on the Trueport utility.

Trueport

Trueport is a com port redirector utility for the Device Server. It can be run in two modes:
zTrueport mode—This mode allows complete device control and operates exactly like a directly
connected serial port. It provides a complete COM port interface between the attached serial
device and the network.
zTrueport Lite mode—This mode provides a simple raw data interface between the device and
the network. Although the port will still operate as a COM port, control signals are ignored. In
this mode, the serial communications parameters must be configured on the Network Access
Server.
You use Trueport when you want to connect extra terminals to a server using a Device Server rather
than a multi-port serial card. Trueport is especially useful when you want to improve security, for
example, to see which user is logged onto which terminal. When run on UNIX, Trueport allows you
to print directly from a terminal to an attached printer (transparent printing). You can also remap the
slow baud rate of your UNIX server to a faster baud rate, as shown below.
perle
Network Serial Connection
Ethernet
UNIX, running
Trueport Daemon,
baud rate 115,200
Map UNIX baud
rate 115,200 to
230,400 for faster
throughput PC
Currently, Trueport is supported on:
zAIX 4.x, 5.x
zSolaris (x86) 2.6, 2.7, 2.8, 2.9
zSolaris (SPARC) 2.8, 2.9, supporting both 32-bit and 64-bit modes
zSCO Unixware 7 (and SCO Open UNIX 8)
zSCO OpenServer 5.0x
zNCR SVR4 (Trueport Lite only)
zLINUX
zWindows 2000/Server 2003/NT/XP
zHPUX 10.x, 11.x