Perle Systems S-1110PP, S-1110DPP manual Installation, Auto-MDIX Jumper Settings

Installation

The default DIP switch settings (all switches in the UP position) will work for most installations.

These are the steps required to configure the Perle S-1110P Ethernet media converter:

1.Insert SFP Module (SFP Model only).

2.Set the Auto-MDIX jumper setting (optional).

3.Set the DIP switch settings (if required).

4.Set the Powering Option Jumpers (if required).

5.Install and connect the fiber cable(s).

6.Install and connect the copper cable(s).

7.Power up the media converter.

Auto-MDIX Jumper Settings

Note: The factory settings for Auto-MDIX will work for most installations, but in the rare case that you need to modify the settings, the procedure is below.

For dual copper media converters, each copper interface has an Auto-MDIX jumper bank. To access the Auto-MDIX jumper settings, unscrew the six side screws on the case and remove the cover plate. Locate the MDIX AUTO jumper set as detailed below. By covering or strapping pins 1 and 2, the S-1110P will operate as an MDIX device. By covering or strapping pins 2 and 3, the S- 1110P will automatically detect the Ethernet cable’s polarity. Removing the strapping is the same as AUTO.

Note: The default jumper setting is AUTO

Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter	5
Installation Guide