Installing the Copper Cable | Perle Systems S-1110PP, S-1110DP

Installing the Copper Cable

1.Locate 10/100/1000Base-T compliant copper cables with the appropriate connectors.

2.Connect the RJ-45 cable between the Perle media converter and the device.

Note: The Perle media converter supports Auto-MDIX which allows connection of a straight-through or cross-over Ethernet cable. See Auto-MDIX Jumper Settings in this guide for jumper positions.

Grounding the Media Converter

If your installation requires additional grounding the following procedure can be followed.

Grounding the chassis requires the following items:

∙One grounding lug (not provided).

∙One 18 - 12 AWG wire (not provided).

∙Cross-head screwdriver (not provided).

Note: For your safety, when installing this equipment, always ensure that the chassis ground connection is installed first and disconnected last.

Attaching the Grounding Lug

1. Attach the grounding lug to one end of an 18-12 AWG wire.

Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter	17
Installation Guide

Image 17

Perle Systems S-1110PP, S-1110DP Installing the Copper Cable, Grounding the Media Converter, Attaching the Grounding Lug

Contents

1110P 1110PP 1110DP 1110DPP Installation Guide Port Models Overview Dual Copper / PoE DP Connector Mode Wavelength Port Models SFP Port Models SPF Auto-MDIX Jumper Settings Installation UTP copper Power Power Sourcing PinoutsPoE PoE+ Powering Options Jumper Settings Bank DIP SwitchesBank Auto Negotiation copper Switch DIP Switch Settings BankLink Mode Switch Switch Position Copper Switch Position Fiber Port Fiber Fault Alert Switch Illustration of the FFA Duplex copper SwitchSwitch Position Copper port Switch Fiber Position Mbps Up default Auto Down Off Speed copper SwitchAuto Fiber Negotiation Switch Switch Position 1 Switch Position 2 Type Loopback Fiber-1 Switch Loopback Fiber-2 Switch Switch Position Mode Redundant Primary Switch Fiber Redundancy Switch Dual fiber models only Installing the Simplex Fiber Cable Installing the SFP Fiber ModuleInstalling the Duplex Fiber Cable Attaching the Grounding Lug Installing the Copper CableGrounding the Media Converter Attaching the Power cord strain relief clip Powering up the Perle Media Converter LED Pattern OperationStatus LED Error conditions Pause Ieee 802.3xy Other FeaturesAuto-MDIX General TroubleshootingNo connectivity Method No Power to the PD Fiber Optic Specifications Technical Specifications 1110PP-S1SC120U Min Ethernet Copper Cabling Requirements Fiber Cabling Requirements Compliance Information EN 55022, Class a EN 55024, Class a Laser Safety IEC Copyright Warranty / RegistrationContacting Technical Support