Illustration of the FFA
The following diagram is an illustration of the operation of this feature.
(A)– Remote Media Converter setup for Fiber Fault Alert Enabled, Fiber Negotiation – OFF and Link Mode – Standard.
(B)– Local Media Converter setup for Fiber Fault Alert Enabled, Smart Link
1 – (A) Loses fiber connection on its receiver.
2 – (A) Sends FFA.
3 – (B) Detects FFA signal and shuts down the fiber link.
4 – (B) Drops link on copper connection because Smart Link
5 – (A) Link on copper connection is not affected because Smart Link Mode is set to Standard.
Duplex copper (Switch 4)
Switch Position | Copper port 1 | Copper port 2 |
|
|
|
Up (default) | Full Duplex | NA |
|
|
|
Down | Half Duplex | NA |
|
|
|
Note: When Auto Negotiation (SW1) is set to Off, the media converter will use this Duplex setting for copper port 1.
Full Duplex: In the Up switch position; the media converter will be set to Full Duplex mode.
Half Duplex: The media converter will be set to Half Duplex mode.
Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter | 11 |
Installation Guide |
|
