Green – 1000 Mbps
Orange – 100 Mbps
Off – 10 Mbps (if link is currently established)
On – Full Duplex Mode
Off – Half Duplex Mode
LKC-1/2 (Link Status on Copper port 1/2)
On – Copper link is present
Off – No copper link present
Blinking (slow) – Copper link appears functional – Copper link has been brought down by Smart Link
Blinking (fast) – Copper link up and receiving data
PSE-1/2
Solid Green (Active) – The PSE has successfully detected a compliant PD and is applying power over the UTP.
Solid Orange (Inactive) – The PSE is not active. The PSE has been configured to provide power, however
∙a compliant PD is not detected - no power applied
∙a PSE has turned off power for Reset function
Off – (Disabled) The PSE function is disabled in the configuration.
Error conditions
A blinking red light is an error condition. The led light will cycle with a 3 second stop interval between the error condition code.
| |
1 blink | PD Capacitance too high |
2 blinks | PD Resistance too low or short circuit |
3 blinks | PD Resistance too high |
20 | Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter |
| Installation Guide |
