40
Line Commands
send-name
When enabled, the port name will be sent to the host upon session initiation.
Default: Disabled
session strings
Controls the sending of ASCII strings to serial devices at session start and session
termination as follows;
zSend at Start—If configured, this string will be sent to the serial device when the
serial device is detected (i.e. signals come up). The maximum size of this field is
128 bytes/characters. Non printable ascii characters must be entered in this format
<027>. The decimal numbers within the brackets must be 3 digits long (example
003 not 3).
zSend at End—If configured, this string will be sent to the serial device when the
TCP session on the LAN is terminated. The maximum size of this field is 128
bytes/characters. Non printable ascii character must be entered in this format
<027> (escape). The decimal numbers within the brackets must be 3 digits long
(example 003 not 3).
zDelay after Send—If configured, a delay time is sent to the device. This delay can
be used to provide the serial device with time to process the string before the
session is initiated.
Range: 0-65535 ms
Default: 10 ms
sess-timer
Enter a time, in seconds, for which the Session Timer will run. Use this timer to
forcibly close the session (connection). When the Session Timer expires, the IOLAN
will end the connection. The default value is 0 seconds so the port will never timeout.
The maximum value is 4294967 seconds (about 49 days).
stop-bits
Specifies the number of stop bits that follow a byte.
term-type
Specifies the type of terminal connected to the line:
zDumb
zWYSE60
zVT100
zANSI
zTVI925
zIBM3151TE
zVT320 (specifically supporting VT320-7)
zHP700 (specifically supporting HP700/44)
zTerm1, Term2, Term3 (user defined terminals)
user
For DSLogin line service, makes this a line that is dedicated to the specified user. Only
this user will be able to log in on this line and they won’t need to enter their login name
- just their password.