The OSD Controls
directions. (Note: INPUT SELECTION is not available on all monitors. If not on your monitor, RESET TO FACTORY SETTINGS is your last selection.)
… to exit completely, press the 
button.
RETURN TO TOP OF THE PAGE
INPUT SELECTION (not available on all monitors)
INPUT SELECTION allows you to decide whether the video input into your monitor comes from a digital or analog source. This is determined by how the video signal is sent from your computer to your monitor.
To find out if the signal is digital or analog, first consult the owner's manual for your computer. Second, make sure you have the correct connection made to your monitor. If your computer supports both analog and digital output or if you have two computers connectors to your monitor (one with analog output and one with digital output), you can also use this setting to switch between the two video signals as desired.
1)Press the OK button on the monitor. The MAIN CONTROLS window appears. LANGUAGE is highlighted.
2)Press the 
button until INPUT SELECTION is highlighted.
3)Press the 
button. The INPUT SELECTION window appears.
4)Press the 
or 
button to select either ANALOG or DIGITAL.
file:///E/manual/english/150P/osd/osd_cont.htm (18 of 20) [12/13/1999 8:01:22 PM]
