Philips DTR, 210 Operation, Switch-on/switch-off, Initial installation, Arrow button or, Button

Operation

English	Switch-on/switch-off
	Switch the receiver on by pressing the ON/OFF button
	(standby button) on the remote control and wait until you
	see the welcome image on your screen.

The LED is off if the receiver is switched on.

When you switch on your receiver for the first time, the LED is blinking while the software is loading. Follow the steps explained in the section Initial installation on this page.

When the reciever is in stand-by mode the LED is red.

During a software update process the LED is blinking.

Initial installation

After the first switch-on, you'll receive the following wel- come window:

1Press the OK button to proceed to the next page.

2On the next page, select the desired language by pressing

the arrow button or	, and again press the OK
button.

The settings window is displayed:

Note: Also observe the information messages displayed on the screen. These will help you to set the correct values. Also with regard to further operation, information messages are dis- played.

3Now successively set the desired values. In doing so, observe the following:

10OPERATION

-	By using the arrow buttons	or	, you change the
	displayed values,
-	By using the arrow buttons	or	, you switch

between the individual setting possibilities.

4Then highlight the OK field by using the arrow button

or behind adopt, and press the OK button.

The next window is displayed:

Note: The displayed values for the start and stop frequency can normally be maintained.

5If desired, change the values for the start and stop fre-

quency by using the arrow buttons	or .
6 By means of the arrow buttons	or , you define the

channels to be selected: all channels, or channels that are free-to-air only.

7Then highlight the OK field by using the arrow button

or next to start scan mode, and press the OK button.

The scan mode is started. The screen dialog thereby pro- vides information on the progress of the channel search.

Note: By pressing the EXIT button, you can stop the scan mode at any time.

As soon as the search is completed, an according message is displayed. Acknowledge this and the following message by OK, in order to proceed to the TV replay.