Philips 28PW9520/12 Connect Peripheral Equipment, Recorder VCR-DVD+RW, Side connections

Connect Peripheral Equipment

There is a wide range of audio and video equipment that can be connected to your TV. The following connection diagrams show you how to connect them.

Depending on the versions, the TV set is equipped with 2 or 3 SCART connectors EXT1, EXT2 and EXT3 located on the rear.

Note: EXT. 1 can handle CVBS and RGB, EXT. 2 CVBS and Y/C, EXT. 3 CVBS and RGB. It is preferred to connect peripherals with RGB output to EXT. 1 or EXT. 3 as RGB provides a better picture quality.

If your recorder is provided with the Easylink function, it should be connected to EXT. 2 to benefit from the EasyLink functionality.

Recorder (VCR-DVD+RW)

CABLE

2

EXT.

1

2

3

4

Connect the aerial cables 1, 2 and, to obtain the optimum picture quality, eurocable 3 as shown.

If your recorder does not have a euroconnector, the only possible connection is via the aerial cable.You will therefore need to tune in your recorder’s test signal and assign it programme number 0 or store the test signal under a programme number between 90 and 99, see Manual installation, p. 6. See the handbook of your recorder.

Decoder and Recorder

Connect a eurocable 4 to your decoder and to the special euroconnector of your recorder. See also the recorder handbook. See Decoder, p. 8. You can also connect your decoder directly to EXT. 1 or 2 with a eurocable.

Other equipment (satellite receiver, decoder, DVD, games, etc.)

&Connect the aerial cables 1, 2 and 3 as shown (only if

			your peripheral has TV aerial in-/output).
CABLE			Connect your equipment with a eurocable 4 or 5 to one of
			the euroconnectors EXT.1, 2 or 3 to obtain a better picture
			quality.
1		1	é Look for the test signal of your peripheral in the same way as
		2	EXT.
			you do for a recorder.
4			“ Make a selection in the Setup, Source menu, p. 8.
	3	5
2

Side connections Camera or Camcorder

S•VIDEO

VIDEO AUDIO

1 2 3

&Connect your camera or camcorder as shown.

éConnect to VIDEO 2 and AUDIO L 3 for mono equipment. For stereo equipment also connect AUDIO R 3. S-VHS quality with an S-VHS camcorder is obtained by connecting the S-VHS cables with the S-VIDEOinput 1 and AUDIO inputs 3.

Do not connect cable 1 and 2 at the same time. This may cause picture distortion !

Headphone

&Insert the plug into the headphone socket L as shown.

éPress ¬ on the remote control to switch off the internal loudspeakers of the TV.

The headphone impedance must be between 8 and 4000 Ohm. The headphone socket has a 3.5 mm jack.

In the Sound menu select Headphone volume to adjust the headphone volume.

15