1717

Audio- and video equipment keys

B
b
¬
+
-
V
+
-
P
v
b
i0
hq
Select
VCR DVD SAT AMP CD
MENU
OK
123
456
789
0
Ò
®
‡π
†
Active Control
S
®
®
®
®
æ
Bto switch to standby
Sfor pause (VCR,DVD,CD)
®for record,
Òfor rewind (VCR,CD);
search down (DVD,AMP)
‡for stop
πfor play
†for fast forward (VCR,CD);
search up (DVD/AMP)
æto select your choice of
subtitle language (DVD);
RDS news/TA (AMP);
to shuffle play (CD)
bto select a dvd title;
RDS display (AMP);
info on screen (CD)
idisplay information
MENU to switch the menu on or off
-P+ for chapter, channel, track
selection
0 to 9 digit entry
0tape index (VCR),
select a DVD chapter,
select a frequency (AMP)
UVCR timer
Qsurround on/off (AMP,CD)
cursor up/down
to select the next or the
previous disc (CD)
cursor left/right
to select the previous or
following track (CD)
search up/down (AMP)

Record with your recorder with EasyLink

In TV mode, it is possible to start a direct recording of the programme which is
being displayed on the TV screen. Continue to press the ®record key on the
remote control for more than 2 seconds.
Note:
Switching programme numbers on your TV does not disturb recording !
When recording a programme from a peripheral connected to EXT. 1,EXT. 3 or SIDE,you
can not select another TV programme on the screen.
This system remote control operates the following Philips equipment:TV,VCR,
DVD, SAT (RC5),AMP (+TUNER), CD;
Press the Select key to operate any of the equipment indicated in the display.
Another device can be selected by pressing Select repeatedly within 2 seconds.The
led will blink slowly to indicate the device.
Press one of the keys on the remote control to operate the peripheral equipment.
To r eturn to TV mode press Select while the led is blinking.
When no action is taken within 60 seconds, the remote goes back to TV mode.
Note:When the Select key is pressed and held for more than 2 seconds, the RC5/RC6
system select command is transmitted.
Additionally the DVD, SAT and CD indicator can be programmed to operate the
DVD-R, SAT (RC6), CD-R instead.
&Press the Select key repeatedly until no LED is lit.
éTo program DVD-R,press the OK key + digit 2.
To program SAT (RC6),press the OK key + digit 4.
To program CD-R,press the OK key + digit 6.
From now on, when the corresponding (DVD,SAT,CD) indicator is selected,
the remote control will operate your DVD-R, SAT (RC6) or CD-R.
Note:To return to the modes programmed in the factory, either remove the batteries for a
few minutes, or press the OK key + digit 1 (DVD mode); or + digit 3 (SAT-RC5) or +
digit 5 (CD mode).