15
Satellite Receiver with a recorder &Connect the RF Antenna or Cable TV cable 1to
the RF IN socket of your recorder.
éConnect another RF cable 2from the output of
your recorder to the TV’s 75 øxjack.
“Connect the satellite antenna cable 3to the
satellite receiver’s SATELLITE INjack.
‘Connect the AV cables 4to the satellite receiver’s
AV OUT jacks and to the VCR’s AV IN jacks.
(Connect the recorder’s AV OUT jacks 5to the TV’s
AV2 INjacks.
DVD player or other accessory digital source equipment
Equipment with AV connectors only
&Connect the video cables to the equipment’s
AV OUT jacks and to the TV’s AV1 or AV2 IN
jacks.
éConnect the audio cables to the equipment’s
AUDIO L and Rjacks and to the L AUDIO and
R AUDIO AV1or AV 2 jacks on the TV.
(According to where you connected the video
cables,to AV 1 or AV2.)
Equipment with an S-VIDEO connector
&Connect an S-video cable the AV2
S-VIDEO input.
Note:When using the s-video connector do not
connect any device to the video input.
éConnect the audio cables to the equipment’s
AUDIO L and Rjacks and to the L AUDIO and
R AUDIO AV2jacks on the TV.
With Component Video Output Connectors
&Connect the cables of your YPbPr equipment
1to the YPbPr input AV1 INsockets on the
TV.
Note:The YPbPr sockets on the TV are compatible
with 480i (interlaced,1 Fh) output signals only, not
480p (progressive scan,2 Fh).
éFor reproduction of CVI (Component Video
Input) and in order to have correct picture
reproduction,also connect a video cable to
video of AV1 2.
Note:This connection is used for AV1 (CVBS).
“Connect the Audio left and right (only for
stereo devices) cables 2to the AUDIO L and
Rinput of AV1.
Remark:Equipment may also be connected to the
AV IN jacks (SIDE) at the right side of the TV.
Warning:Never connect a signal to the Y-input
and video-input at the same time.This may
cause picture distortion !
Equipment with Progressive scan output
(480p or 1080i 2 Fh)
Connect the equipment to the AV4 INjacks on
the TV.
See AV3 or AV4 Digital HD input, next page.
Note:The labels for the component video sockets
may differ depending on the DVD player.Although
the abbreviations may vary,the letters B and R
stand for the blue and red component signals,
respectively,and Y indicates the luminance signal.
Refer to the DVD player’s instructions for use for
definitions and connection details.
AV 2
in
AV 1
in
Monitor
out
VIDEO
L
R
Y
Pb
Pr
AUDIO S-VIDEO
REC
CABLE
SAT
≈
IN OUT
SAT
IN
OUT
IN
OUT
AV 2
in
AV 1
in
Monitor
out
VIDEO
L/Mono
R
Y
Pb
Pr
AUDIO S-VIDEO
5
75 3
4
2393.2 en.qxd 06-09-2004 11:19 Pagina 15