4 Use your TV
Switching on your TV and putting it in Standby mode
TV
Remote Control
To Turn the TV On from Standby or Off to Standby
●Press B on the Side panel or the Remote Control.
Note(s)
●Energy Consumption contributes to air and water pollution. When the AC Power Cord is plugged in, your TV consumes energy with a very low standby Power Consumption.
Adjusting Volume
TV
Remote Control
To decrease or increase Volume
●Press VOL J / K on the Side panel or press VOL + / – on the Remote Control.
VOL J
VOL K (+) : Volume Up
To mute or unmute sound
●Press V on the Remote Control to mute the sound.
●Press V again or VOL + / – to recover the original sound.
22 .English
Switching Channels
TV
Remote Control
To select Channels by using CH H / I or CH + / –
●Press CH H (Up) / I（Down) on the side panel or press CH + / – on the Remote Control.
To select Channels by using the NUMBER buttons
Digital TV Operation
●For Digital channels, press a number followed by a dot “•” and the corresponding sub channel number.
–When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–When selecting Cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
●To select the
●Channel not available or No Signal will appear on the TV screen after the subchannel broadcast is over.
●Audio Only message will appear on the TV screen, when you receive only sound signal.
Continued on next page.
