Philips 32PFL4609, 43PFL4909, 43PFL4609, 65PFL4909, 55PFL4909, 49PFL4609 Manual network settings

Manual network settings

2Use H I to select Manual network settings, then press OK.

Network settings assistant	Network selection	Wireless
Manual network settings	Wireless network setting	Auto
Connection test	IP configuration	IP setting mode
Setting status	Proxy configuration	Proxy setting
Home network
Reset network settings

Network selection

3Use H I to select Network selection, then press OK.

4 Use H I to select the desired setting, then press OK.

Wired	If you connect to an Ethernet cable, select Wired
	to connect to the Internet.
Wireless	If you have a router with WPS function, select
	Wireless to connect to the Internet.

Wireless network setting

This menu is displayed only when you set Wireless in Network selection. In order to use a wireless network, you must set up a connection to the AP (e.g. wireless router).

3Use H I to select Wireless network setting, then press OK.

Auto

Search for wireless networks automatically and select the SSID from the list.

4Use H I to select Auto, then press OK.

5The list of wireless networks will be displayed. Use H I to select the appropriate the SSID, then press OK.

Auto	Router 1	Enter Key
Manually enter your SSID	Router 2	Select
	Router 3	Enter Key
	Router 4	Select

●If you select the SSID with , WEP*2 / WPA / WPA2 Key entry

screen will appear. Enter the WEP*2 / WPA / WPA2 key of the selected wireless network using H I J K, then press OK.

●If you select the SSID has a WPS, the WPS setting screen will appear. Use H I J K to select a setting, then press OK.

41 .English

	Select this setting if your router has a Wi-Fi
	Protected Setup (WPS) button. Start scanning
Easy Connect	for wireless networks on the TV after pressing
	the WPS button on your router. If connection
	test fails, try Easy Connect again.*1 If it fails then
	refer to the router’s manual for more details.
	Select this setting if your router has a WPS but
WPS code	does not have a WPS button. Enter the 8-digit
	WPS PIN code shown on your TV in the router
	settings menu via PC before Connect is selected.
	If your wireless network with authentication
	setting (WEP*2, WPA or WPA2), WEP*2 /
Manual	WPA / WPA2 Key entry screen will appear. Enter
	the WEP*2 / WPA / WPA2 key of the selected
	wireless network using H I J K, then press
	OK.

*1 WPS (Easy Connect) cannot be used when the security protocol is set to WEP. Change the Access Point’s security mode from WEP to WPA or WPA2 (recommended).

*2 WEP is not recommended to be used due to its Major security flaws. Change the Security protocol on the wireless router to WPA or WPA2 (recommended) mode.

Confirmation message will appear. Select OK to complete the settings.

Note(s)

●For a wireless network with authentication setting, key icon appears to the right hand of the SSID.

●Signal icon shows the strength of the signal.

●WEP*2 / WPA key appears as asterisks on the confirmation screen.

●The wireless LAN supports following specifications.

–Wireless standards: IEEE 802.11 b/g/n

–Frequency spectrum: 2.4GHz

–Security protocol: WEP*2 / WPA / WPA2

Continued on next page.