Philips 5.1 manual Preamp Slider, Fader Slider, Center Slider, LFE Slider, Balance Slider

Models: 5.1

1 40
Download 40 pages 50.6 Kb
Page 26
Image 26
Preamp Slider

Philips Sound Solutions

Preamp Slider

The Preamp Level control allows you to boost the input audio signal before it is processed by the PSA2 HD. It has a similar effect as the master volume, but should not be used instead of it. The Preamp can be particularly useful to boost low level DVD movie soundtracks.

NOTE: Increasing the Preamp may cause audio distortion from saturation on some high level input signal. In some cases, an input signal can be of such amplitude that audio distortion can occur at the preamp default level. If this is the case simply lower the preamp level to help eliminate any distortion.

Fader Slider

You can use this slider to control the balance between the front and the rear speakers.

Center Slider

Center controls the level of output on the center speaker only. Use this slider to adjust the volume on the center speaker.

LFE Slider

This slider allows you to control the volume level of the subwoofer.

Balance Slider

This slider allows you to balance the left and the right speakers. It affects the front and the rear speakers only.

The Loop Playback button allows the test to repeat until the stop button is pressed. If the Loop Sounds is off, the sound will play once for each click of a speaker button.

The Auto button sends the test sound to each speaker once and moves to the next speaker automatically. If the Loop and the Auto buttons are used in conjunction, the test signal will loop through all attached speakers until the Stop button is pressed.

Speaker Connection Considerations

When connecting speakers it is important that you connect them properly to obtain maximum performance. Connecting to the wrong jack will degrade the quality of the sound output.

If you have only two speakers connect to the Front output jack.

If you have four speakers, connect to the Front and Rear output jacks.

If you have six speakers (5.1), connect to the Front, Rear and Center/LFE output jacks. Ensure that labeling of the speakers match the labeling of the jacks, i.e., front speakers to the front jack, rear speakers to the rear jack and so on.

The Ultimate Edge™ Soundcard Users Guide

20

Page 26
Image 26
Philips 5.1 Preamp Slider, Fader Slider, Center Slider, LFE Slider, Balance Slider, Speaker Connection Considerations