Connect the telephone line cords to the telephone | Philips 954

INSTALLATION

4Connect the telephone line cords to the telephone.

• Four One-Line Jacks

Modular

Telephone Jacks

Lines 3 and 4

Modular

Telephone Jacks

Lines 1 and 2

Standard

Electrical

Outlet

Telephone Jacks

Telephone	Power Cord
Line Cords

•Two Two-Line Jacks

Modular

Telephone Jack

Lines 3 and 4

Modular

Telephone Jack

Lines 1 and 2

Telephone Jacks

Standard

Electrical

Outlet

Telephone	Power Cord
Line Cords

5Connect the power adapter to the telephone.

Use only the power adapter provided with this product. To obtain a replacement, call 1 800 PCC–9125.

Plug one end of the power adapter into the jack labeled ADAPTER on the back of the phone.

7

Lucent 0954 book.L1

7

5/7/98, 10:35 AM

Image 10

Philips 954 manual Connect the telephone line cords to the telephone, Connect the power adapter to the telephone

Contents

BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephone Connect the handset cord Connect the power adapterCheck for dial tone Wall Installation Reverse the handset tab Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the Clock Change Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer Off Auto Redial Switch Between LinesRedial Hold Temporary Tone Dialing MuteFlash Conference Calls Transferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced Call Timer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory Number Intercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call or Making an Intercom Conference Call Paging All PhonesAnswering an Allpage Room Monitor Case of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SET Expanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant Station Answering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line