Mount the phone on the wall | Philips 954 instruction

INSTALLATION

6Mount the phone on the wall.

• Four One-Line Jacks

Modular

Telephone

Jacks Lines

3 and 4

Telephone

Line Cord

Modular

Telephone

Jack Line 1

Telephone

Line Cord

Standard

Electrical

Outlet

Modular	Power Cord
Modular
Telephone
Jack Line 2

•Two Two-Line Jacks

Modular Telephone Jack Lines 3 and 4

Telephone

Line Cord

Power Cord

Modular

Telephone Jack

Lines 1 and 2

Standard

Electrical

Outlet

NOTE: If you have three modular telephone jacks, mount the phone onto a jack without a wall-mounting adapter. If you have four modular telephone jacks, mount the phone onto a jack without a wall-mounting adapter.

8

Lucent 0954 book.L1

8

5/7/98, 10:35 AM

Image 11

Philips 954 manual Mount the phone on the wall

Contents

BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteries Check for dial tone Connect the power adapterConnect the handset cord Reverse the handset tab Wall Installation Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom Number Set for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer Volume Hold Switch Between LinesRedial Auto Redial Conference Calls MuteFlash Temporary Tone Dialing Transferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced Call Timer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in Memory Intercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call or Room Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference Call Case of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power Failure Expanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex Operation Attendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line