Telephone Feature Setup, Assign Intercom Number | Philips 954

TELEPHONE FEATURE SETUP

Assign Intercom Number

1Do not lift the handset.

2Press G, *, #.

3Enter two digits (11–22).

4Press I. You will hear a confirmation ring.

NOTE: If you duplicate an intercom number, you’ll hear a warning tone. Repeat Steps 1–4 and assign a different number.

5Pry up the intercom number card cover, write the intercom number on the card, and replace the cover.

Set the Clock.

NOTE: You’ll hear a confirmation tone when you enter numbers correctly. If you make a mistake, press and release Sto start over.

1Press and release S. The screen displays zeros.

2Press and release *for AM or #for PM

— OR —

Go on to Step 3 if you want the clock set to military/European time.

3Enter two digits to set the month (for example, press 03for March).

4Enter two digits to set the date (for example, press 09for the ninth).

5Enter one digit for the day of the week (for example, press 1for Sunday or 5for Thursday).

6Enter two digits for the hour (for example, press 01for one o’clock, or 11for eleven o’clock).

7Enter two digits for the minutes (for example, press 31for :31).

Set Dial Mode

1Press G, *, #, *.

2Press and release 2for tone dialing

— OR —

Press and release 3for pulse dialing.

3Press and release M. You’ll hear a confirmation ring if you’ve entered information correctly.

10

Lucent 0954 book.L1

10

5/7/98, 10:35 AM

Image 13

Philips 954 manual Telephone Feature Setup, Assign Intercom Number, Set the Clock, Set Dial Mode

Contents

BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Table/Desk Installation InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephone Connect the handset cord Connect the power adapterCheck for dial tone Reverse the handset tab Wall Installation Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set Dial Mode Telephone Feature SetupAssign Intercom Number Set the Clock Change Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Handset/Speakerphone Volume Control VolumeRinger Volume Turning Ringer Off Redial Switch Between LinesAuto Redial Hold Flash MuteTemporary Tone Dialing Conference Calls Transfer a Call Do Not DisturbTransferring an Announced Call Transferring an Unannounced Call Timer Telephone Memory Directory Card Storing a Temporary Tone Signal in a Memory NumberStoring Numbers in Memory Storing a Pause in a Memory Number Intercom Operation Making an Intercom Call or Basic Intercom OperationsAnswering an Intercom Call or Ending an Intercom Call or Answering an Allpage Paging All PhonesMaking an Intercom Conference Call Room Monitor Case of Difficulty Tone Signals Do Not Activate a Remote Device Intercom Paging Signal Not ReceivedOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SET Expanding the 954 System Setting Up a Fourth Line for Each Station Setup ChecklistCentrex Operation Enabling/Disabling Attendant Station Answering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line