Philips bSure 1 manual projector, the remote control, Set up, Preparation

XP cClear10 English (good) 24-07-2003 15:52 Pagina 14

	3. Set up		<
Moving/transporting the	Preparation
projector	1	Press the Standby button twice to put the projector in Power/Standby.
	– The Standby indicator starts blinking orange.
	2	Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
		Standby) and disconnect the mains lead and all other cables.
	3	Put the lens cap back in place to prevent dust, dirt or other contamination from harming or
		damaging the front of the projector lens when moving the projector.

Never place the projector on the side where the connections are located.

Moving/transporting the projector

The projector contains many glass and precision parts. If you need to transport the projector, please follow these packing instructions to prevent accidental damage to the projector.

•When you are hand-carrying the projector, be sure to use a carrying case like the softbag supplied.

•When shipping the projector, use the original packaging material if possible. If you do not have the original packaging, use equivalent materials, placing plenty of cushioning around the projector.

•When transporting the projector as freight or checked luggage, first put it in a carrying case, then pack it in a firm box, using cushioning around the case.

Inserting the batteries in	1	Push and slide the lid in the direction of the arrow.
the remote control	2	Install two ‘AAA’ batteries as indicated inside the battery compartment.
	3	Replace the lid and snap it into place.

Note The maximum range of the remote control is approximately 15 m (± 50 feet).

Philips Multimedia Projector 14 English User guide cClear