Philips bSure 1 manual Maintenance, Cleaning

Models: bSure 1

1 47
Download 47 pages 15.69 Kb
Page 41
Image 41
Cleaning

XP cClear10 English (good) 24-07-2003 15:52 Pagina 41

Cleaning

Caution

6

AV

Source

Menu

OK

Mute

 

 

 

Lamp

Stand

by

Temp

Important

A

Notes6. MaintenanceManual backgroundManual backgroundB

C

C

A

Manual backgroundManual backgroundManual backgroundB

Notes

6. Maintenance

>

Switch off and disconnect the projector before cleaning.

1Press the Standby button twice to switch off the projector.

– The Standby indicator starts blinking orange.

2Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in Standby) and disconnect the mains lead and all other cables.

Cleaning the cabinet

When the cabinet is dusty, clean it by gently wiping with a soft cloth.

A chamois leather slightly moistened with water is sufficient for cleaning the housing.

Do not use cleaning agents as they may harm the housing.

Cleaning the lens

When the lens is dirty or dusty, first blow the dust off and then gently wipe with a soft brush or lens cleaning paper. Never touch the lens with your fingers.

The lens is likely to become mouldy if left dirty.

Cleaning the dust filter

Make sure to clean the dust filter regularly.

1Switch off the projector and wait until the cooling fan has stopped before disconnecting the projector.

2Turn the projector over and place it on a soft surface. Never place the projector on the side where the connections are located!

3Press tab A and remove filter holder B from the projector.

4Press clamp C, open the holder and remove the filter.

5While firmly holding the filter, gently remove any accumulated dust, from the dusty side, with a vacuum cleaner.

6Press clamp C, put the filter back in place and release clamp C. Firmly press the filter edges in place.

7Close the filter holder.

8Press tab A and insert the filter B into the projector.

We advise you to clean the filter every 100 hours. Operating the projector without filter or with a torn or damaged filter may seriously damage the projector.

When the filter is damaged replace it with a filter of the same type (12 nc: 3122 434 0157 0).

The projector power cannot be switched on again unless the filter holder is installed correctly.

Philips Multimedia Projector

41

English User guide cClear

 

 

 

Page 41
Image 41
Philips bSure 1 manual Maintenance, Cleaning