C.
Hooking Up Your TV/VCR with the Supplied Rod Antenna
To install the supplied rod antenna, push the base stem of the antenna into the antenna hole on the back of the TV/VCR. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.
Hooking Up the TV/VCR (cont’d) 7
Rod Antenna
(supplied)
2
Connect the AC power cord to the AC 120V jack on the back of the TV/VCR. Plug the AC power cord into an AC power outlet.
Use only the supplied AC power cord.
3
Before you turn on the TV/VCR, go to page nine.
Helpful Hint
• Before connecting an antenna or cable signal to the ANT(enna) Jack, make sure the pin is not bent. If the pin is bent, straighten it as illustrated, then connect the antenna or cable signal to the ANT(enna) Jack.
Bent pin
Crooked Pin
CablePlug
