Philips CID3692 user manual Connect radio antenna, Mount in the dashboard

2Stick the other end of the GPS antenna to a metal surface of the car.

Connect radio antenna

If your car has built-in radio antenna, connect it to the radio antenna of the system for better radio signal.

1Connect the radio antenna to the car antenna.

Mount in the dashboard

Note

•Check wire connections before you mount the unit into a car.

•If preset radio stations are lost when the ignition key is turned OFF and then back ON, reconnect the red leads crosswise to the yellow ones.

1 If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car battery.

•If you disconnect the car battery in a car that has an on-board drive or navigation computer, the computer may lost its memory.

•If the car battery is not disconnected, to avoid short-circuit, ensure that bare wires do not touch each other.

2Ensure that the horizontal slant of the car dashboard opening is between 0 and 20 degrees. The unit cannot be used if the dashboard opening’s slant angle is above 20 degrees.

3Fix the mounting brackets to the unit with screws (supplied by the car manufacturer).

4Slide the unit into the dashboard and fix it to the car with four screws.

10EN