Have another IP Address displayed | Philips CPWBS001 manual

60ENGLISH

C. I have another IP Address displayed

If you have another IP address listed then the PC may not be configured for a DHCP connection. Please refer to “Configuring Client TCP/IP” for information.

Once you have confirmed your computer is configured for DHCP, then please follow the steps below.

1.Open a DOS window as described above.

2.Type ipconfig/release.

3.Then type ipconfig/renew.

D. The 10/100 LED does not light after a connection is made.

1.Check that the host computer and the Wireless Base Station are both powered on.

2.Be sure the network cable is connected to both devices.

3.Verify that Category 5 cable is used if you are operating at 100 Mbps.

4.Verify that the length of any cable does not exceed 100 m (328 ft).

5.Check the network card connections.

6.The RJ-45 port on the Wireless Base Station, network card, or cable may be defective.

Image 60

Philips CPWBS001 manual Have another IP Address displayed, 10/100 LED does not light after a connection is made

Contents

Wireless Base Station ➊ ➋ Helpline Table of Contents Reset button PowerIndicator LEDs Technology for people Safety Precautions Packaging contentsImportant information Environmental information Disclaimer Do not make any hardware connections to the Wireless Base Station until the Setup Wizard asks you to do soStart installing the software You make any hardware connections How to use the Setup programme Hardware description System Requirements Connect the System Basic Installation Procedure Connecting the Wireless Base Station Attach to Your Network Using Ethernet Cabling Attach to Your Network Using Radio Signals Attach the Wireless Base Station to the Internet Modem / Internet port on the Wireless Base StationEnds for all connections Connecting the Power Adapter Installing TCP/IP Setting Up TCP/IPWindows Configuring Your Computer in Windows 98SE/Me Dhcp IP Configuration Obtain IP Settings from Your Wireless Base Station Configuring Your Computer in Windows Configuring Your Computer in Windows XP Dhcp IP Configuration Configuring a Macintosh Computer Manual IP Configuration for all Windows OS Verifying Your TCP/IP Connection Ping Browser Configuration Disable Proxy ConnectionInternet Explorer 5 or above Internet Explorer for Macintosh Setup, virtual DMZ hosts, and other advanced functions Making Configuration ChangesNavigating the Web Browser Interface DSL modem Setup Wizard Time ZoneBroadband Type Cable Modem Fixed-IP xDSL PPPoE xDSL Click Finish to complete the setup Pptp Point-to-Point Tunneling Protocol Menu Description Password Settings System Factory defaults. The default is no password Default 9 minutesRemote Management Base Station Internet Settings Dynamic IP Point-to-Point Over Ethernet PPPoE Point-to-Point Tunneling Protocol Pptp Static IP DNS Local netwerk LAN Wireless Channel and Ssid Default Fully Automatic Available options are 1, 2, 5.5, and 11Mbps. Default AllCommunicates with PCs in its service range. Default Auto Available channel settings are limited by local regulations Encryption Network Address Translation NAT Address Mapping Virtual Server Special Applications 6112Battle.net 28800 Access Control Firewall As shown in the following screen MAC Filtering Table Parental Control Schedule Rule Enables Schedule-based Internet access control Use this section to create your network schedule rules Firewall Configuration Intrusion Detection DMZ Demilitarized Zone Ddns Dynamic DNS Settings UPnP Universal Plug and Play Setting Tools Configuration Tools Tools Tools Firmware Upgrade Tools Reboot Complete when the power LED stops blinking Following items are included on this screen StatusSection Description Displays Internet connection type and status Troubleshooting Am getting an IP Address that starts with Have another IP Address displayed 10/100 LED does not light after a connection is made Media Access Control LED IndicatorsRF Specification Standards RF Output Power RF Power ConsumptionRF Frequency Operating Channel English 0682