Configuring a Macintosh Computer | Philips CPWBS001 specification

22ENGLISH

Configuring a Macintosh Computer

DHCP IP Configuration

You may find that the instructions here do not exactly match your screen.

This is because these steps and screenshots were created using Mac 9.0- or

Higher

1.Pull down the Apple Menu. Click Control Panel and select TCP/IP.

2.In the TCP/IP dialog box, make sure that Ethernet is selected in the Connect via: field.

3.Select Using DHCP Server in the Configure field.

4.Close the TCP/IP dialog box.

Image 22

Philips CPWBS001 manual Configuring a Macintosh Computer

Contents

Wireless Base Station ➊ ➋ Helpline Table of Contents Indicator LEDs Reset buttonPower Technology for people Important information Safety PrecautionsPackaging contents Environmental information Disclaimer Start installing the software Do not make any hardware connections to the Wireless BaseStation until the Setup Wizard asks you to do so You make any hardware connections How to use the Setup programme Hardware description System Requirements Connect the System Basic Installation Procedure Connecting the Wireless Base Station Attach to Your Network Using Ethernet Cabling Attach to Your Network Using Radio Signals Modem / Internet port on the Wireless Base Station Attach the Wireless Base Station to the InternetEnds for all connections Connecting the Power Adapter Setting Up TCP/IP Installing TCP/IPWindows Configuring Your Computer in Windows 98SE/Me Dhcp IP Configuration Obtain IP Settings from Your Wireless Base Station Configuring Your Computer in Windows Configuring Your Computer in Windows XP Dhcp IP Configuration Configuring a Macintosh Computer Manual IP Configuration for all Windows OS Verifying Your TCP/IP Connection Ping Disable Proxy Connection Browser ConfigurationInternet Explorer 5 or above Internet Explorer for Macintosh Navigating the Web Browser Interface Setup, virtual DMZ hosts, and other advanced functionsMaking Configuration Changes DSL modem Broadband Type Setup WizardTime Zone Cable Modem Fixed-IP xDSL PPPoE xDSL Click Finish to complete the setup Pptp Point-to-Point Tunneling Protocol Menu Description Password Settings System Remote Management Factory defaults. The default is no passwordDefault 9 minutes Base Station Internet Settings Dynamic IP Point-to-Point Over Ethernet PPPoE Point-to-Point Tunneling Protocol Pptp Static IP DNS Local netwerk LAN Wireless Channel and Ssid Communicates with PCs in its service range. Default Auto Default Fully AutomaticAvailable options are 1, 2, 5.5, and 11Mbps. Default All Available channel settings are limited by local regulations Encryption Network Address Translation NAT Address Mapping Virtual Server Battle.net Special Applications6112 28800 Access Control Firewall As shown in the following screen MAC Filtering Table Parental Control Schedule Rule Enables Schedule-based Internet access control Use this section to create your network schedule rules Firewall Configuration Intrusion Detection DMZ Demilitarized Zone Ddns Dynamic DNS Settings UPnP Universal Plug and Play Setting Tools Configuration Tools Tools Tools Firmware Upgrade Tools Reboot Complete when the power LED stops blinking Section Description Following items are included on this screenStatus Displays Internet connection type and status Troubleshooting Am getting an IP Address that starts with Have another IP Address displayed 10/100 LED does not light after a connection is made RF Specification Media Access ControlLED Indicators Standards RF Frequency RF Output PowerRF Power Consumption Operating Channel English 0682