Philips D750 manual Identifying, Camp-on busy COB

16 A – Telephone operation: 2 Telephoning: Basic functions

2.9Identifying

”Identifying” is the transfer and display of your own telephone number on the telephone of the other party. Y

1.If you call someone yourself (identification with outgoing calls).

2.If you are called, as soon as you accept the call (identification for incoming calls). The caller can read your telephone number in his/her display (assuming the caller’s telephone has a display). This can be very important in cases where the call has been diverted.

When ordering an ISDN line, you can specify whether the telephone number display transfer should always be suppressed or not.

Prerequisite for changing over the identification:

1.Telephone number transfer must be available for your ISDN line.

2.The ISDN function ”selective identification changeover” must be available as a feature for your line. This changeover facility must then be activated as an additional feature at your SmartLine D750 (see 5.12: Additional function”Identification changeover”).

Once you have performed the settings, you can use the changeover facili- ties described here (identification off = suppression of telephone number transfer). The changeovers can be used differently for incoming and out- going calls.

2.9.1Basic setting

You can set the transfer of your telephone number (= identification) to be always on or off (on delivery: switched on). For the prerequisites for this feature, please refer to the previous section. The menus described here are only offered when these prerequisites are fulfilled.

Identification	-
with outgoing		or
calls
	switch on or off –	store setting
Identification	-	-
with incoming		or
calls
	switch on or off -	store setting

A –ourTelephonetelephoneoperation:number can be2 transferred:Telephoning: Basic functions 17

2.9.2Temporary identification changeover

Identification can be changed over temporarily (for the following call). The basic setting (see 2.9.1) is not altered by this.

The above mentioned prerequisites also apply for temporary identification changeover.

You receive a call: Switch over before taking the call.

You wish to make a call: Switch over before dialing the telephone number.

The following is offered in the display (if necessary, select using the cursor keys):

•”” with basic setting identification = On. or:

•” ” with basic setting identification = Off. Press the O.K. key to temporarily change over identification.

If identification was changed over prior to manual dialing, this changeover is also transferred to the number redial memory.

2.10Camp-on busy (COB)

Another incoming call during a telephone call is signalled to you acoustically by the camp-on busy tone. You can accept or reject the call. You can switch the authorisation for camp-on busy on or off (on delivery: on).

You are in the middle of a call. A 2nd call is signalled:

Accepting - call is offered -

a call Accept call

You are connected with the caller, the 1st call is put on hold.

End the 2nd call: press the disconnect key

You are reconnected with the first party.

You can also end the 1st call by replacing the handset. The camp-on call is then signalled as a normal telephone call.

Rejecting	You are in the middle of a call. A 2nd call is signalled:
a call
	-	call is offered -	Rejecting a call

The caller hears the a ringing tone. If the answering device is switched on, it takes the call

Camp-on busy:	-	-
Switching
authorisation		or
on and off	Switch on or off –	store setting