17
English
Setting Up your DVD/VCR, VCR Operation
Changing the Language
If you want to change the language used on
the TV screen menus,follow the steps below.
1Press the VCR button,then the MENU but-
ton.
2Press the PLAY Bor STOP Cbutton to
select INITIAL,then press the FF gbutton.
3Press the PLAY Bor STOP Cbutton to
select LANGUAGE,then press the FF g
button.
4Press the PLAY Bor STOP Cbutton to
select your desired language.
5Press the MENU button.
A Status Display
To check the Counter,or Clock & Channel
number,press the DISPLAY button.
If the display shows an abnormal read-
ing;
When power is off,press the RESET button
on the bottom of the DVD/VCR with the tip
of a pen etc.The DVD/VCR will reset the all
setting for VCR features including timer
recordings,the clock and the language set-
tings.In this case, you need to reset these set-
tings.
3If playback does not start automatically,press
the VCR button,then press the PLAY Bbut-
ton.
4Press the STOP Cbutton to stop playback
and press the STOP/EJECT Abutton on the
DVD/VCR to remove the tape.
Note:
– When playing a S-VHS format,you can’t
get the high resolution picture and noise
lines may appear on the picture.
IF A TAPE IS ALREADY IN THE
DVD/VCR
Using the buttons on the DVD/VCR
Just press the PLAY Bbutton on the
DVD/VCR.Power will automatically turn on
and playback will start.(Direct Button
Operation)
Using the buttons on the remote con-
trol
Press the STANDBY-ON button to turn on,
and then press the PLAY Bbutton.
Recording a Video Cassette Tape
1In stop mode,insert a tape with its record
tab intact into the cassette compartment.
aCST.IN light appears on the front of
DVD/VCR.
2Press the SPEED button until the desired tape
speed appears briefly.
3Use the P +/– buttons or the numerical key
pad button to select the TV channel to be
recorded.
4Press the REC button to start recording.
●If a tape without a record tab is in the
DVD/VCR,the DVD/VCR will eject the tape.
5Press the PAUSE kbutton once to pause the
recording temporarily.
6Press the PAUSE kbutton again or the REC
button to resume recording.
7To stop recording,press the STOP Cbutton.
Note:
– Changing tape speed during recording
will cause distortion on the tape.
RESET
button
FRONT SIDE
<BOTTOM VIEW>
Playing a Video Cassette Tape
1Turn on the TV and set the correct channels
per your DVD/VCR channel.
2With the DVD/VCR power off,insert a tape
in the cassette compartment.
aPlayback will start automatically,if the
tape’s record tab has been removed.
●If the DVD/VCR power was already on,press
the SOURCE button to switch to VCR mode.